How to fix “STOP: 0X00000050” error message in windows 7?



Encountering STOP error messages, generally called as BSOD (Blue screen of death) and blue screen of doom indicates major problems taking place in Windows system. Whenever critical situations are faced by the system such as malfunctioning hardware or poorly written device drivers STOP error is shown by the system. As error messages such as STOP 0X00000050 is displayed at boot up data file and folders stored in the hard drive cannot be accessed. Backup is the most common means of restoring data; however its unavailability can be accomplished with Windows 7 file recovery to recover inaccessible and missing data.



Get Software         



To better understand the problem, suppose that any new third party software is installed on Windows 7 system that uses WFP (Windows Filtering Platform) callout driver. Later on when software is installed and you try booting your system, below written Stop message is found displaying on the system-


“STOP: 0X00000050 (parameter1, parameter2, parameter3, parameter4) PAGE_FAULT_IN_NONPAGED_AREA” , where value of parameter depends upon the system configuration.
Major problem is that it is not at possible to access data.


Cause: - Basically this happens so as there exists some problem in TCPIP.sys system driver. When FwpsReleaseClassifyHandle () function is executed by WFP callout drive in order to free system resources, error is received.


To resolve page fault in non paged area error, registry has to be modified but as this involves lot of risk and can adversely harm if done wrongly, it is mostly not opted for. Owing to this formatting hard drive is comparatively better although it will cause data loss, recovering which is a matter of seconds using advanced windows recovery software.FAT 16, FAT 32, NTFS & NTFS5 file system, windows 2000, XP, 2003, vista and windows 7 are supported for recovery in all cases deletion, corruption, format etc.



**All Pictures and Logos used are trademark of respective Company.